How to do the Simple Braid

  1. The first step is to brush your hair to remove any tangles
  2. Next separate your hair into three sections
  3. Take one of either of the side sections and cross it over to the other side leaving the middle section and pull to tighten
  4. Take the opposite side of hair that you didn’t cross and cross it over and tighten again
  5. Repeat steps 3 and 4 until you run out of hair or you want to stop
  6. You should end up with a beautiful braid

 

Advertisements

How to Keep Your Converse White

                                                             WASHING MACHINE                                                                                     One way is to wash them and after, if the souls are dirty, rub them with Mr. Clean magic eraser.  When washing take laces out; Still put them in the washer too.  NEVER PUT THEM IN THE DRYER.  You need to let them air dry.  Also, if it is raining or muddy it is best not to wear them.  They will get dirty.        all-star

       BAKING SODA AND VINEGAR       Another way is to use baking soda and vinegar. DO NOT USE RED VINEGAR. Take laces out. Soak shoes in soapy water then rinse with cold water. Combine both ingredients in PLASTIC  bowl. It will make a paste. Use a tooth brush or any type of brush to apply the paste to the shoes. After you have completed this process rinse with cold    water. Put the in the washing machine and                                                                                                    let them air dry.

                               TOOTHPASTEtoothbrush           Toothpaste is another way you can clean your converse. Make sure the toothpaste you are using is a NON-GEL kind. Use a toothbrush and apply to your converse. Let it sit in for about 10 minutes. After the 10 minutes are up wipe it off with a damp towel. If needed you can do this a couple more times. After, to make sure they are extra clean, put them in the washer. This will do the finishing touches and take some of the leftover paste you might have not removed. Let them air dry.

I hope these methods helped  you clean your converse! I know getting them white can be a challenge but these tips should help you overcome that. Bye-bye old, dirty converse…. hello new, white converse!!

How To Do A Fishtail

  • Brush hair to remove any unnecessary tangles
  • Separate hair into two sections
  • Take a small section of hair from one of the sections  and cross it over to the other section and add that piece of hair to the other section
  • fishtailNow, on the other section, take a small section of hair and cross over to the other section and add that piece of hair to it
  • Continue this process until you run out of hair or just have the fishtail as long as you want.
  • If you want a tight fishtail make sure you  tighten the hair after each strand of hair. If you want a loose don’t tighten it to much but still tighten
  • Secure it with a rubber band.
  • Also, if you want a high fishtail start with a pony tail and then do the process.
  • You will end up with a beautiful looking fishtail that is great for any occasion.